Texas Plumbers: Basics Of a Toilet
Toilet Plumbing Solutions
Toilets are made in two basic shapes – elongated and round. Colors vary (colored fixtures are more expensive than white), As durable as this material is, it is subject to scratching and chipping and should be handled with care on the job. There are three different flushing actions commonly used in toilets for residences. These result from bowl design and, although they have been available for years, few individuals are familiar with their differences or the advantages of one over the other. Consequently, price has frequently been the determining factor in bowl selection, resulting later in dissatisfaction.please visit our other website here
Bowl designs
The wash-down bowl discharges into a trap way at the front; it is most easily recognized by a characteristic bulge on the front. It has a much smaller exposed water surface inside the bowl, with a large flat exposed china surface at the front of the interior of the bowl. Since this area is not protected by water, it is subject to fouling, contamination, and staining. The trap way in the wash-down bowl is not round, and its interior is frequently irregular in shape because of the exterior design and the method of manufacture. Characteristically, the wash-down bowl does not flush as well or as quietly as other bowls. You are suggested to always prefer experienced Texas Plumbers for your entire plumbing enquiry such as sink fitting, heating solutions, basin services, pipes and much more. Many municipal code authorities no longer accept this type of bowl, and many manufacturers have deleted it from their manufacturing inventory.
Reverse trap: The reverse trap bowl discharges into a trap way at the rear of the bowl. Most manufacturers™ models have a large exposed water surface, thereby reducing fouling and staining of the bowl interior. The trap way is generally round, providing a more efficient flushing action. Siphon jet: The siphon jet is similar to the reverse trap in that the trap- way also discharges to the rear of the bowl. All models must have a large exposed water surface, leaving less interior china surface exposed to fouling or contamination. The trap way must be large and engineered to be as round as possible for the most efficient drainage system and flushing action. The basic differences between the siphon jet and the reverse trap bowls are in these areas, both minimums being larger in the siphon jet to assure better flushing action and less bowl contamination.
Installing Toilet
There is usually either a 3-inch copper waste pipe or a 4-inch lead pipe coming up through the floor that is 12 inches (to the center of the pipe) from the finished wall. On a ceramic tile floor a brass toilet flange is installed directly on the floor; otherwise, you must use a marble slab under it. Different toilet flanges are made use of, like with lead or copper pipe, and you need one to match the kind of waste pipe there is. The flange you use may be either straight or offset if there is copper. The offset flange gets more or less clearance from the wall if the waste pipe is not exactly right. If a lead pipe is not exactly right for the flange to fit, it may be dressed (bent) by tapping it gently with a dressing tool or with a hammer handle to fit. Lead is soft, so fitting should be no problem. More information here
Leave A Comment